MODEL VS-GSWG SWING GATE OPENER

Varible Speed, Linear Drive Swing Gate Operator
Heavy Duty Industrial Use

Cabinet:	Electrical:
Weather-resistant galvannealed steel cabinet with powder coat finish Lockable, gasketed, hinged and removable front cover for easy	Variable speed - soft start/soft stop programmable through an inverter motor control (voltage & phase of input power supply required at time of order) Available from 1/2 to 2 hp industrial continuous-duty, three-phase, 56-frame motor Available in all standard voltages and phases Run timer for clutch and motor protection Delay on reverse Master/Slave capability built in Easily convertible right hand/left hand Solid state control circuit Double C-face brake Power on/off switch Duplex receptacle on 115 VAC units Three-button control station included Accessory connections are 24-volt AC or DC Easily adjustable rotary limit switches Full system capable for access controls and reversing devices
Mechanical:
Heavy-duty 60:1 right-angle C-face gear reducer Adjustable torque limiter Linear drive arm Heavy-duty pillow-block bearings
Mounting:
3 - 3 1/2" OD post mounting Optional pad mounting pedestal available
Manual Release:	Anti-Entrapment/Detection Devices:
Manual release is located inside the operator enclosur	Operator is pre-wired to accept contact and non-contact detection devices such as contact edges and/or photo electric eyes
Warning Signals:
Warning beeper to sound when gate is moving

Comparison chart for all our OSCO Swing Gate Openers

 

Ordering the VS-GSWG Swing Gate Operator:

Model	HP	Voltage	Phase	Type Drive	Maximum Gate Operator Width	Seconds to Open Gate	List Price		Order Now
Variable Speed - Industrial Swing Gate Opener
VS-GSWG-211	1/2	115	Single	Linear	45 ft	18-22 Sec.	$3,674.11
VS-GSWG-121	1	230	Single	Linear	40 ft	18-22 Sec.	$3,940.15
VS-GSWG-783	2	208	Three	Linear	36ft	18-22 Sec.	$4,415.69

2500-2015 - 100 ft. cable Master/Slave communication wire... $75.00
Double-swing-- Two Operators required- Slave capability is built in
2500-2207 - Low Voltage Surge suppressor .................... $42.00
2510-262 - 115V Heater ............................................. $112.00
2510-273 - 230V Heater .............................................. $175.00
2520-354 - 460V Heater ............................................... $250.00

 

Caution: Barrier gates are not for pedestrians! Automatic gate operators are designed for vehicular traffic only.Tthey are powerful and can cause serious injury or death. Accordingly, direct all pedestrian traffic to a separate pedestrian gate. UL325 requires the use of contact or non-contact anti-entrapment devices. ASTM F2200 requires that all exposed rollers are covered.